Installation guide

Installing the SSR-600
SSR-600 Installation Guide 3-9
5. Repeat steps 1 through 4 for the other side.
6. The SSR-600 may be mounted with the back of the unit facing out of
the rack. In this position, the screws will be attached along the bottom
edge of the SSR-600 (the SSR-600 must be right-side up). Otherwise,
all other instructions apply, substituting the back of the SSR-600 for
the front in the instructions.
7. Position the SSR-600 between the vertical frame members of the
19-inch rack, as shown in Figure 3-9.
Figure 3-9 Installing the SSR-600 in a 19-Inch Rack
8. Fasten the SSR-600 to the rack with the mounting screws shipped with
the 19-inch rack.
9. The rackmount installation is complete.
The rack mount brackets in this kit are intended for mounting
the SSR-600 in a 19-inch rack for a static environment. Do not
ship a 19-inch rack with the SSR-600 mounted in it. Damage
may occur to the brackets and the SSR-600.
Mounting Screws (4)
19-Inch Rack
2012_10
RESET
PWR
CPU
LNK
STS
SPD/100
XMT
RCV
SPD/100
XMT
RCV
10/100 10/100
ETHERNET 1 ETHERNET 2
WIDE AREA 2WIDE AREA 1
TELCO TELCO
CONSOLE