Specifications

9031755 E6 Introduction
1-5
MicroMMAC-T and SPMA
• Chapter 8, Configuring and Monitoring an Uninterruptible Power Supply,
introduces the UPS sustem (which connects a computer interface port to
an intelligent MIM) and explains how to start, configure, and monitor the
UPS Tool.
• Chapter 9, Using DLM, explains how to manage “smart hub” devices, or
DLM Servers, on your network. Accessing the DLM Application and its
windows, adding/deleting DLM entries, and managing DLM is also
described.
• Chapter 10, Using the Path Tool, explains how to generate a list of router
hops between a managed Cabletron device and a remote destination, and
display specific information about each hop found in the router path.
• Chapter 11, MIB Tree/MIB Tools, provides an overview of the MIB
Browser, the MIB Details tool, the MIB Editor, and browsing the MIB
Tree.
For details on the Bridge view, FDDI Alarm Configuration view, Connection
Policy view, Station List view, SMT/MAC Configuration view, and the Port
Configuration view, refer to the SPECTRUM Portable Management
Application for the Bridge/Router Interface Modules (BRIMs) User’s Guide.
• Section 1:General Information
Chapter 3, Using the Bridge View, describes Bridge Traffic and Detail
view, details how to configure bridge parameters and describes Bridge
Filtering and Special Databases.
• Section 2: FDDI Applications
Chapter 4, Viewing Port Configuration, describes how to enable and
disable BRIM ports and details other features of the Port Configuration
view.
Chapter 5, Alarm Configuration, details how to set alarm threshold and
describes the the fields within the Alarm Configuration view.
Chapter 6, Viewing SMT/MAC Configuration, describes the fields in the
SMT/MAC Configuration view, the MAC Chart, and the MAC Meter.
Chapter 7, Configuring the SMT Connection Policy, describes the
connections allowed among the four FDDI port types: A, B, M (Master),
and S (Slave).
Chapter 8, Viewing the Station List, details how to confugure physical
ports on your BRIM, as well as how to configure PPP protocol and the
Frame Relay protocol. It also describes the assignment of protocols to
interfaces, and how to add circuits to the Frame Relay protocol.