Specifications

ST1kChnlApp Trunk Group Application Status
SPECTRUM Enterprise Manager 98 of 194 Ascom TimePlex ST-1000
Path
A read-only value. For TDM and subrate
channels, each hop of the path is indicated using
three bytes. The first two bytes are the node
number. The most significant bit of the first byte
of the node number will be set to one if the
channel is connected at a subrate speed and the
node contains an SGM. The third byte identifies
the INL that the channel passes through. For
packet channels, each hop of the path is
indicated using five bytes. The first two bytes are
the node number. The third and fourth bytes are
the nest and slot numbers, respectively, of the
FSM that this packet channel passes through.
The fifth number identifies the INL that the
channel passes through.
RouteQuality
A read-only value that is either
asSpecified or
overRiden .
ConnectTime
A read-only value indicating the time since this
channel was connected. The value indicates the
time as the number of seconds since midnight on
January 1, 1970.
Trunk Group Application
Status
This view lets you sort, find, and update the
status indications for the trunk group addresses.
Trunk Group Contents Status
This view provides the following fields, which are
all read-only.
Addr
The address of the trunk group.
SequenceID
Used to index multiple ports assigned to this
trunk group.
SrcNodeID
The value of the source node ID of the current
channel.
SrcTrkGrpAddr
The value of the source trunk group address of
the current channel.
SrcChAddr
The value of the source end point address of the
current channel (T1M/E1M port) using this trunk
group.