Specifications

ST1kAd10App AD 10 Status Administration
SPECTRUM Enterprise Manager 82 of 194 Ascom TimePlex ST-1000
HdlcLineCode
A read-write field giving the line code. The
possible values are
nrz and nrzi .
HdlcIdleFill
A read-write field giving the idle fill. The possible
values are
idle and flag .
HdlcMinFlags
A read-write field giving the minimum number of
flags between frames. The possible values range
from
1 to 16 .
ModemSigInfo
A read-write field giving the modem signal bit
map, which is as follows: bit 1 (lsb) is RTS, bit 2 is
DTR, bit 3 is CTS, bit 4 is DCD, and bit 5 is DSR.
VcMapDlci
An integer value ranging from
0 to 1023 .
VcMapCir
The committed information rate in units of 100
bps.
TDMDataRate
A read-only field giving the TDM data rate. The
value of this field must match the value of the AD
10 data port TDM data rate. If it does not match,
the reset AD 10 data port command can be used
to synchronize them. The possible values are
listed below.
Type
A read-only field having a possible value of
tdm-
sync
, stat-mux-async , bisync , or hdlc . The
value of this field must match the value of the AD
10 data port type. If it does not match, the reset
AD 10 data port command can be used to
synchronize them.
DtrFILpDlyDelta
The DTR falling edge (going from high to low)
delay is this field plus the value of DtrLoopDelay.
RtsFILpDlyDelta
The RTS falling edge (going from high to low)
delay is this field plus the value of RtsLoopDelay.
b1200 b2400 b4800 b7200
b9600 b12000 b14400 b16000
b16800 b19200 b24000 b28800
b32000 b38400 b48000 b56000
disabled