Specifications

ST1kLgmApp LGM Port Administration
SPECTRUM Enterprise Manager 61 of 194 Ascom TimePlex ST-1000
Encrption
A read-write field the determines whether
encryption is used. The possible values are
encrypted and normal (the default value).
SyncLevel
A read-write field that determines the
synchronization level. The possible values are
level1 (the default value) and level2 .
SyncChar
A read-write field that specifies the number of
sync characters per frame. The possible values
are
syncChar8 and syncChar4 (the default value).
SatelliteHop
An integer value from 0 to 4 that specifies the
number of satellite hops per end-to-end point
connection. An earth station to satellite to earth
station connection represents one hop. The
default value is
0 .
DosTimer
A read-write value from 1 to 300 (seconds). An
Out-Of-Service state will be entered if this time is
exceeded. The default value is
16 .
PartitionID
A read-write value from 1 to 1023 that is used by
the security server to enforce shared node.
BitMode
A read-write field that defines the bit mode of this
port. The possible values are
b7Bit and b8Bit
(the default value).
InbandSuperrate
A read-write field that specifies how the signaling
function transport for inband superrate is
handled.
nack means reject a channel connection
with a no bandwidth response, so an alternative
link path may be found.
forceActive (the default
value) means set all the functions active.
pass
means pass the functions the way they are set
(slower than link).
InbandSubrate
A read-write field that specifies how the signaling
function transport for inband subrate is handled.
nack means reject a channel connection with a no
bandwidth response, so an alternative link path
may be found.
pass (the default value) means
pass the functions the way they are set (slower
than link).
OutBandSuperrate
A read-write field that specifies how the signaling
function transport for outband superrate is
handled.
nack means reject a channel connection
with a no bandwidth response, so an alternative
link path may be found.
forceActive (the default
value) means set all the functions active.
pass