Specifications

ST1kModuleApp Port Status Administration
SPECTRUM Enterprise Manager 57 of 194 Ascom TimePlex ST-1000
NumberOfBundles
This field is not applicable to the E3 port. It
always displays
0 .
PhasorStatus
All 0 bits indicate normal. Abnormal bits are
defined as listed below.
If the port does not have a phasor, the value will
be
x8080 .
Bits 6 and 7 are applicable only to an SDM
module and reflect the KG-resync lines status as
listed below.
MappedPhy
For virtual port addresses, this field indicates the
physical port that this address is mapped to. If
the virtual port address is not mapped to a
physical port, then
0.0.0 displays. For physical
port addresses, this field indicates the virtual port
that is mapped to this port. If no virtual port is
mapped to this physical port address, then
0.0.0
is displayed.
SdmFunction
This field applies primarily to SDM ports. The bit
map is:
1 = DSR if DTE, DTR if DCE
2 = DCD if DTE, RTS if DCE
3 = reserved
Bit Meaning Bit Meaning
1 receive phasor
underflow
9 transmit phasor
underflow
2 receive phasor
overflow
10 transmit phasor
overflow
3 receive phasor empty 11 transmit phasor
empty
4 receive phasor full 12 transmit phasor full
5 receive phasor fifo
error
13 transmit phasor fifo
error
6 KGROS status 14 KG status is not
applicable
7 KGLOS status 15 reserved
8 receive phasor not
applicable
16 transmit phasor not
applicable
Bit 6 Bit 7 KG Status
0 0 OK disabled/disabled
1 0 ERR enabled/disabled
0 1 ERR disabled/enabled
1 1 ERR enabled/enabled