Specifications

ST1kModuleApp Slot Configuration
SPECTRUM Enterprise Manager 47 of 194 Ascom TimePlex ST-1000
ST1kModuleApp
This application provides access to slot, NCP, and port status information.
The Icon Subviews menu for this application
provides access to the device specific views listed
below.
• Slot Configuration on Page 47 provides slot
condition and type information.
• Slot Status on Page 53 provides slot format
and status information.
• NCP Module Status on Page 54 provides NCP
module address and version information.
• NCP Flash PROM Status on Page 54 provides
NCP module flash PROM address, type, and
version information.
• Port Status Administration on Page 55
provides condition, loopback, and signal
status information.
Slot Configuration
This view provides the fields described below.
Some fields are read-write and can be changed by
double-clicking them and making the changes in
the ensuing Detail view.
Slot Address
A read-only value for the slot address.
Start Mode
The possible modes are
automatic , off , and
erase. Setting this field to erase will fail if any of
the following conditions are true: (1) the module's
redundant mode is set to one-to-one redundancy;
(2) the module has any unremoved INLs; (3) the
module has any channels that are not
disconnected; and (4) there is hardware present
in the slot and the module is in an active or
standby state or is going into an active or standby
state (i.e., is initializing or loading). Otherwise,
erase will erase the module configuration and all
of the ports, bundles, INLs, and channels on the
module.