Specifications

ST1kAccessApp Root Node IP Access Information
SPECTRUM Enterprise Manager 45 of 194 Ascom TimePlex ST-1000
disabled, the command will do nothing.
resetModemPort loads the new CPI port settings.
As a side effect, the current session will be logged
off.
enableCpsSession switches the modem port
from SLIP mode to CPI mode. The mode will be
changed back to SLIP after a nodal power cycle or
a reset modem port command.
ModemControlUpdate
A read-only field having a value of
loaded or
resetReq (the default value).
ModemSpeed
A read-write field that sets the speed in units of
bps. The possible values are
a2400 , a4800 , a9600
(the default value),
a14400 , and a19200 .
ModemDataBits
A read-write field having a value of b7 or b8 (the
default value).
ModemParity
A read-write field having a value of
noParity (the
default value),
even , or odd .
ModemStopBits
A read-write field having a value of b1 (the default
value) or
b2 .
ModemControlLead
A read-write field having a value of eIA or noEIA .
Root Node IP Access
Information
This view contains read-only fields that display
the IP Control Update status and WAN IP address.
The view also displays the IP online subnet
address information.
Root Node IP Access Config
This view provides address information for the IP
offline subnet configuration and the following
fields.
WAN Ip Address
A read-only field giving the WAN IP address.
IP SubNetwork Mask
The network ID mask for ST-50 network.
Root Gateway IP
The root node Ethernet port IP address.
Root Gateway Mask
The network mask for root node's Ethernet port.
This is the mask for the user device's IP network.
Root Gateway Ethernet
A read-write field that specifies the Ethernet
protocol of the user device's IP network. The