Specifications

ST1kAccessApp CPI/Modem Access Control
SPECTRUM Enterprise Manager 44 of 194 Ascom TimePlex ST-1000
HwRsc
Defines access rights for a community entry to
the resource configuration hardware resource
MIB section (recfHwRsc). The possible values are
noAccess , readOnly , and readWrite (the default
value).
CPI/Modem Access Control
The Craft Person Station/Modem Access Control
Configuration view contains two areas, CPI Port
Configuration and Modem Port Configuration.
These areas let you set the CPI port and modem
port configurations.
CPI Port Configuration
This area of the Craft Person Station/Modem
Access Control Configuration view contains the
following fields.
CpiControl
A write-only field having a value of
resetCpiPort
or
logoff . logoff terminates a session that was
enabled by entering a password. If password
control is disabled, the command will do nothing.
resetCpiPort loads the new CPI port settings. As
a side effect, the current session will be logged off.
CpiControlUpdate
A read-only field having a value of
loaded or
resetReq (the default value).
CpiSpeed
A read-write field that sets the speed in units of
bps. The possible values are
a2400 , a4800 , a9600
(the default value),
a14400 , and a19200 .
CpiDataBits
A read-write field having a value of b7 or b8 (the
default value).
CpiParity
A read-write field having a value of
noParity (the
default value),
even , or odd .
CpiStopBits
A read-write field having a value of b1 (the default
value) or
b2 .
Modem Port Configuration
This area of the Craft Person Station/Modem
Access Control Configuration view contains the
following fields.
ModemControl
A write-only field having a value of
enableCpsSession , resetModemPort , or logoff .
logoff terminates a session that was enabled by
entering a password. If password control is