Specifications

St1kNodeApp Node Status
SPECTRUM Enterprise Manager 27 of 194 Ascom TimePlex ST-1000
PktBand BW Avail
An integer value from
0 to 2147483647 .
PktBand BW Max
An integer value from 0 to 2147483647 .
Total Dsm Calls/Sec
An integer value in calls per second.
Node Status Diagnostics
A write-only field that you set to one of the
following:
update nest , update clock table ,
select clock1 , select clock2 , select clock3 ,
select clock4 , select clock5 , select clock6 ,
select clock7 , select clock8 , enable test
gen local
, enable test gen remote , disable
test gen
, turn on major alarm relay , turn
off major alarm relay
, turn on minor alarm
relay
, turn off minor alarm relay , clear Ncp
Bg Diag results
, or clear Ncp startup Diag
results
.
TestGen Status
The current status of the test generator for TDM
nDS0 channels. The possible values are
idle ,
good , and error .
TestGen TDM Channel
The current channel address that the TDM test
generator is being used on.
Alarm Relay Status
Indicates whether the alarm relay port is
programmed to be used or not. The possible
values are
enabled and disabled .
Alarm Relay Sub Status
The status of the major alarm relay (first value)
and the minor alarm relay (second value). The
possible values are
onOn , onOff , offOn , and
offOff . This field is only valid if the alarm relay is
enabled.
Modem Status
The current status of the modem port. The
possible values are
idle , inCpsSession , and
inEmsSession .
Cpi Status
The current status of the CPI port. The possible
values are
idle and inSession .
Softload Status
The softload status. idle means that no softload
has been run since the node went online.
softloading indicates that a download is
underway from an SNMS, CPS, or other node.
copyToStandbyNcp means that a file is being
transferred from the active NCP to the standby
NCP.
copyToModule means that a file that is not
stored on the NCP is being transferred to the
module that is responsible for storing the file.