Specifications

ST1kDsmPortApp DSM Port Specific Administration
SPECTRUM Enterprise Manager 182 of 194 Ascom TimePlex ST-1000
D-Channel Port Real Call Status
Administration
This area of the DSM Port Specific Administration
view provides the following fields.
Addr
The address of the D-channel port associated
with this real call, in the format
type.group.port.
Bundle
The B-channel used for this real call.
Contents
The Call Detail Record for a real call in progress
on a D-channel. Real calls are those that involve
B-channels. The bytes in a CDR for a call in
progress are interpreted the same as the
interpretation for CDRs associated with active
virtual calls. See CDRContents on Page 177.
Layer2Status
A read-only field that indicates the Layer 2 status
of a real call from the point of view of the DSM.
The possible values are
pending , in-service ,
layer2Timeout , layer2Mismatch , and
notApplicable . notApplicable is displayed for
the D-channel bundle if the DPNSS protocol is
used and for the bundles not used for the D-
channel if the Q.Sig and ISDN-Q.931 protocol is
used.
Layer2State
A read-only field that indicates the Layer 2
protocol state of a real call from the point of view
of the DSM. The possible values are listed below.
The values between 1 and 127 are used for
DPNSS states. The values between 128 and 254
are used for Q.Sig and ISDN-Q.931 states.
notApplicable is displayed for the D-channel
bundle if the DPNSS protocol is used and for the
bundles not used for the D-channel if the Q.Sig
and ISDN-Q.931 protocol is used.
awaitCallVirtChannelResponse awaitNcpReleaseResponse
awaitNcpReleaseNoResponse awaitNcpRelease
awaitNcpDisconnect awaitNcp
notApplicable
1 idle 2 ready
3 waitingForResponse 4 waitingForEstablishment
5 outOfService 129 unassignedTEI
130 assignAwaitingTEI 131 establishAwaitingTEI
132 assignedTEI 133 awaitingEstablishment