Specifications

ST1kDsmPortApp DSM Port Specific Administration
SPECTRUM Enterprise Manager 180 of 194 Ascom TimePlex ST-1000
• 87: Source Nest ID
• 88: Source Slot ID
• 89-90: Destination Node ID
• 91: Destination Nest ID
• 91: Destination Slot ID
• 93: Calling Number Size (number of bytes, not
string length). This number is referred to
below as x.
• 94 (93+x): Calling Number
• (94+x): Called Number Size (number of bytes,
not string length). This number is referred to
below as y.
• (95+x)-(94+x+y): Called Number
• (95+x+y): Routing Digits
• (96+x+y): Unused
• (97+x+y): Source TEI
• (98+x+y): Destination TEI
• (99+x+y): Unused
• (100+x+y): Unused.
Layer2Status
A read-only field that indicates the Layer 2 status
of a virtual call from the point of view of the DSM.
The possible values are
pending , in-service ,
layer2Timeout , layer2Mismatch , and
notApplicable . notApplicable is displayed for
the D-channel bundle if the DPNSS protocol is
used and for all virtual calls if the Q.Sig protocol
is used.
Layer2State
A read-only field that indicates the Layer 2
protocol state of a virtual call from the point of
view of the DSM. The possible values for the
DPNSS states are
idle , ready ,
waitingForResponse ,
waitingForEstablishment , and outOfService .
The possible values for the Q.Sig states are
unassignedTEI , assignAwaitingTEI ,
establishAwaitingTEI , assignedTEI ,
awaitingEstablishment , awaitingRelease ,
multipleFrameEstablished , and timeRecovery .
notApplicable is displayed for the D-channel
bundle if the DPNSS protocol is used and for all
virtual calls if the Q.Sig protocol is used.
Layer3State
A read-only field that indicates the Layer 3
protocol state of a virtual call from the point of
view of the DSM. The possible values are listed
below.
inactive (1) idle (2)
outgoingService (3) incomingService (4)
awaitNAMOut (5) awaitNAMIn (6)
awaitCCMOut (7) awaitCCMIn (8)