Specifications

ST1kDsmApp DSM Module Specific Status
SPECTRUM Enterprise Manager 159 of 194 Ascom TimePlex ST-1000
- suspend request - the network has
received a request to suspend the call, but
has not yet responded.
- resume request - the network has received
a request to resume a previously
suspended call, but has not yet responded.
- release request - the network has
requested the user device to release and is
waiting for a response.
- call abort - for an incoming call in point-to-
multipoint configuration, the call is being
cleared before any user has been awarded
the call.
- overlap receiving - for an incoming call, the
network has received an acknowledgement
of the call establishment request, which
permits the network to send additional call
information (if any) in the overlap mode.
• 38: Special Profile Type (with values as
defined in the Quality of Service Table
QOSCallType field)
• 39: Info Type (with values of Q.Sig speech,
DPNSS A-law, DPNSS ADPCM, DPNSS Mu-
law, Unrestricted data, Restricted data, 3.1
KHz audio, 7 KHz audio, and video)
• 40: Special Profile Index
• 41: Channel Profile Index
• 42: NCP Clear Cause (with values as defined
in the Recorded Call Detail Record Status
view ChannelState field.
• 43: Clear Cause. The values are defined
below. (If NCP Clear Cause is not zero, this
byte is not used.)
DPNSS values:
- number unobtainable (0)
- address incomplete (1)
- network termination (2)
- service unavailable (3)
- subscriber incompatible (4)
- congestion/collision (7)
- busy (8)
- subscriber out of service (9)
- incoming calls barred (10)
- service incompatible (19)
- acknowledgement (20)
- signal not understood (21)
- signal not valid (22)
- service temporarily unavailable (23)
- facility not registered (24)
- reject (25)
- message not understood (26)
- signalling system incompatible (27)
- route out of service (28)
- transferred (29)