Specifications

ST1kDsmApp DSM Module Specific Status
SPECTRUM Enterprise Manager 157 of 194 Ascom TimePlex ST-1000
Module CDR Record Status
This area of the DSM Module Status
Administration view provides the following fields.
Addr
The address of this DSM module.
LogNum
The CDR log number to be accessed on this DSM
module.
Index
The Call Detail Record to be accessed on this log
based on its position (counting from the oldest
one).
Contents
The Call Detail Record from a module CDR log.
These CDRs are for completed calls.
The bytes in a completed call CDR are interpreted
as follows:
Part 1 Generic Information
• 1: CDR Type (with values of level 1 or level 2)
• 2: Version Number (1 for Release 3.1.0 and
higher nodes)
• 3-4: Partition ID
• 5-6: Call ID
• 7: Protocol (with values of DPNSS, Q.Sig,
ISDN-Q.931, or CAS)
• 8: Unused if the protocol is DPNSS or Q.Sig;
Variant Type (with values of ETSI primary rate
network, ETSI basic rate network, National-2
primary rate network, or National-2 basic rate
network) if the protocol is ISDN-Q.931; or
Variant Type (with values of DTMF VFM or
DTMF AD-10/FR2) if the protocol is CAS.
From this position down, the contents definition
varies, depending on the interface level (CDR
Type). The level definitions are defined below.
Level 1: CDRs (Physical Characteristics).
• 9-12: Originating Time
• 13-16: Answer Time
• 17-20: Disconnect Time
• 21-22: B-Channel Source Node ID
• 23: B-Channel Source Nest ID
• 24: B-Channel Source Slot ID
• 25-26: B-Channel Source Port ID
• 27-28: B-Channel Source Channel ID
• 29-30: B-Channel Destination Node ID
• 31: B-Channel Destination Nest ID
• 32: B-Channel Destination Slot ID
• 33-34: B-Channel Destination Port ID
• 35-36: B-Channel Destination Channel ID