Switch User Manual

Bridge Conﬁguration

11-8 Conﬁguring Bridge Ports

2. Drag down to Bridge/LLC2 LAN Interface Table, and release. The

Bridge/LLC2 LAN Interface Table, Figure 11-3, will appear.

Figure 11-3. Bridge/LLC2 LAN Interface Table

You can conÞgure the following bridge port parameters (except Interface

Number):

Interface Number

This is a sequential number used to identify the interface; it will be assigned

automatically.

Port

This Þeld corresponds to the LAN Card Number. Enter 0 for an FRX4000 or

SmartSwitch 1800 (for RLP0); enter 0 or 1 for an FRX6000. This number must be

identical to the number entered in the LAN Card Number Þeld (see below).

LAN Card Number

This Þeld speciÞes the LAN Card being conÞgured as a bridge port. Enter 0 for an

FRX4000 or SmartSwitch 1800 (for RLP0); enter 0 or 1 for an FRX6000. This

number must be identical to the number entered in the Port Þeld (see above).

Priority

This Þeld prioritizes the interface for trafÞc within the device; the higher the

number, the higher the priority. This priority has no effect on trafÞc exiting the

device. Priorities are conÞgured on all logical interfaces that use a physical frame