Switch User Manual

Conﬁguring Bridge Ports 11-7

Bridge Conﬁguration

Blocked Flag

This value will cause the port to be enabled (if No) or disabled (if Yes) when the

device is powered up or rebooted. Whichever state is selected, the port will

remain in that state until this value is changed or until an enable or disable action

is performed. The default value for this parameter is No.

Adding or Modifying Frame Relay Bridge Ports

First, access the Bridge/LLC2 Frame Relay Interface Table (see ConÞguring

Frame Relay Bridge Ports, page 11-4).

To add a new Frame Relay bridge port:

1. Enter the RLP, Port, and DLCI numbers, and the other conﬁgurable values for

each bridge port.

2. Click on to add your new entry.

To modify an existing entry:

1. In the list box, click to select the Frame Relay Interface you wish to modify.

The selected entry will be highlighted. (Note that you can only modify one

entry at a time.)

2. Edit the ﬁelds, as desired. If you make some changes, and would like to return

to the original values, click on the Refresh button.

3. Click on to modify the selected entry.

To delete an existing entry:

1. In the list box, click to select the Frame Relay Interface you wish to delete. The

selected entry will be highlighted. (Note that you can only delete one entry at

a time.)

2. Click on to delete the selected entry.

Conﬁguring LAN Bridge Ports

You can use the Bridge/LLC2 LAN Interface Table to conÞgure a LAN interface to

operate as a bridge connection to the local LAN. To access the table:

1. Click on to display the Device menu.

NOTE

After you have made system-level changes (such as conÞguring a Bridge Interface), you

must apply those changes by rebooting the FRX or SmartSwitch 1800 device, or through

console management via the [F7] command.