User Guide

15-8 SmartSwitch 1800 4. 0 User G uide, Rev 01
Configuring IPX Filter Applications
IPX Filter Applications determine how filters will be used at the interface. To review
existing applications, press
[C]
at the Configure Filter Definitions and Applications
Menu (or
[A], [A], [E], [F], [C]
from the Main Menu). To configure an application, press
[D]
at the Configure Filter Definitions and Applications Menu. When prompted, enter:
●
Interface number: 0–63
. (The default is
0
.) This identifies the virtual interface.
●
Filter Category
:
0
= RIP,
1
= SAP,
2
= Packet,
3
= RIP Router. (The default is
0
.)
●
Direction
:
i
(inbound) or
o
(outbound). (The default is
o
.)
●
Any other requested information, referring to Table 15-6.
Figure 15-3 Typical IPX Filter Applications Record
[A], [A],[E ], [F],[D]
from Main Menu
Up to 100 filters can be configured, displayed over 9 "pages" (screens).
When finished configuring filter definitions and applications, perform an on-line
update to make the changes effective immediately. Press
[E]
at the Filter Definitions
and Applications Configuration Menu. The changes will be sent to the software.
IPX Filter App lication s
* In ter fac e Numb er 2
* Filter Category 0 RIP
* Direction I–Inb ound
APermit Y
B Filter Application 1 0
C Filter Application 2 0
D Filter Application 3 0
E Filter Application 4 0
F Filter Application 5 0
G Filter App lication 6 0
H Filter App lication 7 0
I Filter App lication 8 0
J Filter Application 9 0
K Filter App lication 10 0
2 Page 2
Option: