Specifications

Chapter 3: Software Installation and Setup
40 SmartSwitch Router 2100 Getting Started Guide
want to make the changes in the scratchpad active by displaying the following
message:
4. Enter yes or y to activate the changes.
Saving the Active Configuration to the Startup Configuration File
After you save the configuration commands in the scratchpad, the SSR 2100 executes the
commands and makes the corresponding configuration changes. However, if you power
down or reboot the SSR 2100, the new changes are lost. Use the following procedure to
save the changes into the Startup configuration file so that the SSR 2100 reinstates the
changes when you reboot the software.
1. Ensure that you are in Enable mode by entering the enable command in the CLI.
2. Enter the copy active to startup command to copy the configuration changes in the
Active configuration to the Startup configuration.
The CLI displays the following message:
3. Enter yes or y to save the changes.
Note:
You also can save active changes to the Startup configuration file from within
Configure mode by entering the save startup command.
The new configuration changes are added to the Startup configuration file stored in the
SSR 2100’s boot flash.
Viewing the Current Configuration
If you want to view the current configuration:
1. Ensure that you are in Enable mode by entering the enable command in the CLI.
2. Enter the following command to display the status of each command line:
The CLI displays the active configuration file with the following possible annotations:
– Commands without errors are displayed without any annotation.
– Commands with errors are annotated with an “E”.
Do you want to make the changes Active [yes]?
Are you sure you want to overwrite the Startup configuration [no]?
system show active-config