Specifications

Table Of Contents

Chapter 3: Software Installation and Setup

36 SmartSwitch Router 2100 Getting Started Guide

6. Enter the show command to show the commands you just entered. Because you have

not activated these configuration changes yet, they are listed in the scratchpad section

of the output. Here is an example:

Note:

The other configuration changes made during this CLI session are also listed.

Active changes are listed in the “Running system configuration section” and

unactivated changes are listed in the “Non-committed changes in

Scratchpad” section.

7. To activate the SYSLOG commands, enter the save active command.

Loading System Image Software

The SSR 2100 operates using the system image software installed in its internal flash chip.

To upgrade the system software and operate using the upgraded image, go through the

following procedure:

1. Display the current boot settings by entering the system show version command, as

shown in the following example:

ssr(config)# show

Running system configuration:

! Last modified from Console on Mon Jan 19 12:37:21 1998

1 : interface add ip en0 address-netmask 10.50.11.22/16

2 : system set dns server 10.50.11.12

3 : system set dns domain mktg.cabletron.com

4 : system set name "ssr"

5 : system set location "Sunnyvale, CA

6 : system set contact "John Smith"

7 : system set hashed-password login jNIssH c976b667e681d03ccd5fc527f219351a

8 : system set hashed-password enable zcGzbO 5d1f73d2d478ceaa062a0b5e0168f46a

9 : snmp set community public privilege read

10 : snmp set target 10.50.11.12 community public

******** Non-committed changes in Scratchpad ********

1*: system set syslog server 10.50.11.12

2*: system set syslog level info

3*: system set syslog facility local0

ssr# system show version

Software Information

Software Version : 2.2.0.0

Image Information : Version 2.2.0.0, built on Thu Jul 30 01:16:15 1999

Image Boot Location: tftp://10.50.89.88/ssr2200

Boot Prom Version : prom-1.1.0.5