Specifications
Table Of Contents
- Notices
- Contents
- Preface
- Features Overview
- Hardware Installation
- Software Installation and Setup
- Powering On and Booting the Software
- Starting the Command Line Interface
- Setting Basic System Information
- Setting Up SNMP Community Strings
- Setting Up Passwords
- Setting the DNS Domain Name and Address
- Setting SYSLOG Parameters
- Loading System Image Software
- Loading Boot PROM Software
- Upgrading the VFS
- Activating Configuration Changes and Saving the Configuration File
- Installing and Starting Cabletron CoreWatch
- Troubleshooting
- Technical Support
- Index
Chapter 3: Software Installation and Setup
30 SmartSwitch Router 2100 Getting Started Guide
Here is an example of the commands and output for configuring SNMP and saving the
changes.
7. After verifying the SNMP configuration, save the changes to the Startup
configuration file by entering the copy active to startup command.
ssr# config
ssr(config)# snmp set community public privilege read-only
ssr(config)# snmp set target 10.50.11.12 community public
ssr(config)# save active
ssr(config)# exit
ssr# snmp show all
SNMP Agent status:
enabled mode
SNMP Last 2 Clients:
10.50.100.53 Mon Mar 30 10:31:27 1998
10.50.100.43 Mon Mar 30 10:31:22 1998
SNMP Chassis Identity:
not configured.
Trap Table:
Index Trap Target Addr Community String Status
----- none configured -----
Traps by Type:
Authentication trap: enabled
Link Up/Down trap: enabled
Community Table:
Index Community String Privilege
1. public READ-WRITE
SNMP statistics:
247019 packets received
246346 get requests
745 get-next requests
184 get-bulk requests
50 set requests
0 bad SNMP versions
1 bad community names
0 ASN.1 parse errors
0 PDUs too big
247018 packets sent
246346 get responses
745 get-next responses
184 get-bulk responses
50 set responses