Specifications
Table Of Contents
- Notices
- Contents
- Preface
- Features Overview
- Hardware Installation
- Software Installation and Setup
- Powering On and Booting the Software
- Starting the Command Line Interface
- Setting Basic System Information
- Setting Up SNMP Community Strings
- Setting Up Passwords
- Setting the DNS Domain Name and Address
- Setting SYSLOG Parameters
- Loading System Image Software
- Loading Boot PROM Software
- Upgrading the VFS
- Activating Configuration Changes and Saving the Configuration File
- Installing and Starting Cabletron CoreWatch
- Troubleshooting
- Technical Support
- Index
SmartSwitch Router 2100 Getting Started Guide 29
Chapter 3: Software Installation and Setup
2. Ensure that you are in Configure mode by entering the configure command in the
CLI.
3. Use the following commands to add an SNMP community string and set a target for
the traps.
Note:
The target IP address must be locally attached to the SSR 2100. You cannot
specify a target that is connected to the SSR 2100 by another router. If the IP
address is more than one hop away from the SSR 2100, configure the
SSR 2100 with a static route to the target so that a cold start trap is sent.
4. Enter the show command to examine the changes accumulated in the scratchpad.
5. Enter the save active command to activate the commands you entered in the previous
steps.
6. To verify the changes, enter the snmp show all command.
snmp set community <community-name> privilege read
snmp set target
<IP-addr> community <community-name>