Specifications
Table Of Contents
- Notices
- Contents
- Preface
- Features Overview
- Hardware Installation
- Software Installation and Setup
- Powering On and Booting the Software
- Starting the Command Line Interface
- Setting Basic System Information
- Setting Up SNMP Community Strings
- Setting Up Passwords
- Setting the DNS Domain Name and Address
- Setting SYSLOG Parameters
- Loading System Image Software
- Loading Boot PROM Software
- Upgrading the VFS
- Activating Configuration Changes and Saving the Configuration File
- Installing and Starting Cabletron CoreWatch
- Troubleshooting
- Technical Support
- Index
SmartSwitch Router 2100 Getting Started Guide 23
Chapter 3
Software
Installation and
Setup
This chapter provides the following software installation and basic setup procedures:
• Powering on and booting the software
• Starting the Command Line Interface (CLI)
• Setting basic system information
• Setting up SNMP community strings
• Setting up passwords
• Setting the DNS domain name and address
• Setting SYSLOG parameters
• Loading system image software
• Loading the boot PROM software
• Activating configuration changes and saving the configuration file
Powering On and Booting the Software
To power on the SSR 2100 and boot the software:
1. Plug the SSR 2100’s power supplies into a power source. Assuming that your power
source is currently active, the SSR 2100 will automatically power on and attempt to
boot using the software image in the motherboard’s boot flash.