Specifications
Table Of Contents
- Notices
- Contents
- Preface
- Features Overview
- Hardware Installation
- Software Installation and Setup
- Powering On and Booting the Software
- Starting the Command Line Interface
- Setting Basic System Information
- Setting Up SNMP Community Strings
- Setting Up Passwords
- Setting the DNS Domain Name and Address
- Setting SYSLOG Parameters
- Loading System Image Software
- Loading Boot PROM Software
- Upgrading the VFS
- Activating Configuration Changes and Saving the Configuration File
- Installing and Starting Cabletron CoreWatch
- Troubleshooting
- Technical Support
- Index
Chapter 1: Features Overview
14 SmartSwitch Router 2100 Getting Started Guide
Per-port Rx • Green – indicates when the port’s transceiver receives packets.
• Orange – indicates when the port’s transceiver receives flow-
control packets.
Per-port Tx • Green – indicates when the port’s transceiver transmits packets.
• Orange – indicates when the port’s transceiver transmits flow-
control packets.
Per-port AN • Green – indicates that the Gigabit port is autonegotiating the
operating mode of the link between full-duplex and half-duplex.
• Orange (intermittent) – indicates that autonegotiation is in
process.
• Orange (solid) – indicates a problem with autonegotiation
configuration.
• Red – indicates an autonegotiation failure. This fault may occur if
the link partner does not support full duplex.
• Off – indicates that autonegotiation has been disabled or the link
is down.
Table 6. Gigabit port LEDs (Continued)
LED Description