Specifications

Table Of Contents
Chapter 37: system Commands
SSR Command Line Interface Reference Manual 37 - 21
Parameters
<system-parm>
System parameter you want to display. Specify one of the
following:
active-config
- Shows the active configuration of
the system
buffer
- Shows how many Syslog messages the SSR’s
Syslog message buffer can hold
bootlog
- Shows the contents of the boot log file,
which contains all the system messages generated during
bootup
contact
- Shows the contact information (administrator
name, phone number, and so on)
date
- Shows the system time and date
uptime
- Show how much time has elapsed time since
the most recent reboot
dns
- Shows the IP addresses and domain names for the
DNS servers the SSR can use
hardware
- Shows hardware information
location
- Shows the SSR’s location
name
- Shows the SSR’s name
poweron-selftest-mode
- Shows the type of Power-
On Self Test (POST) that should be performed, if any
startup-config
- Shows the contents of the Startup
configuration file
syslog
- Shows the IP address of the SYSLOG server
and the level of messages the SSR sends to the server
telnet-access
- Lists the last five Telnet connections
to the SSR
terminal
- Shows the default terminal settings (number
of rows, number of columns, and baud rate)
scratchpad
- Shows the configuration changes in the
scratchpad. These changes have not yet been activated.
version
- Shows the software version running on the
SSR