Specifications

Chapter 28: port Commands
SSR Command Line Interface Reference Manual 28 - 7
port set
Purpose
Set port operating mode and port speed.
Format
port set [
<port-list>
|all-ports] [duplex full|half]
[speed 10Mbps|100Mbps] [auto-negotiation on|off]
[hash-mode m0|m1|m2|m3]
Mode
Configure
Description
Depending on the media type of a port, the
port set
command lets you set various
parameters of each port. For 10/100-Mbps Ethernet, you can set the following:
• Operating mode (half-duplex or full-duplex).
• Port speed (10-Mbps or 100-Mbps). This parameter applies only to ports on the
10/100 line cards.
Note:
By default, all ports use autosensing to detect the operating mode and speed
of the network segment to which they are connected. If you use this com-
mand to set a port parameter, the setting disables autosensing for that
parameter on the port. For example, if you set the speed of a segment to 10-
Mbps, that segment no longer uses autosensing for the port speed and will
always attempt to operate at 10-Mbps.
For Gigabit Ethernet, you can set the following:
• Auto-negotiation
In addition to the media specific parameters, you can also set the hash mode for all
media types using the port set command.
Parameters
<port-list>
|all-ports
Specifies the ports. The
all-ports
keyword ap-
plies the settings you select to all the SSR ports.
duplex full|half
Sets the operating mode to half duplex or full du-
plex. This option is valid for 10/100 Mbps Ethernet
only.