Specifications

Chapter 26: ospf Commands
26 - 22 SSR Command Line Interface Reference Manual
ospf set virtual-link
Purpose
Sets the parameters for an OSPF virtual link.
Format
ospf set virtual-link
<number-or-string>
[state disable|enable] [cost
<num>
] [no-multicast] [retransmit-
interval
<num>
] [transit-delay
<num>
]
[priority
<num>
] [hello-interval
<num>
]
[router-dead-interval
<num>
] [poll-interval
<num>
]
Mode
Configure
Parameters
<number-or-string>
The identifier for this virtual link.
state disable|enable
Enables or disables the virtual link.
cost
<num>
The cost associated with this virtual link. The
cost of all interfaces that a packet must cross to
reach a destination are added to get the cost to
that destination. The default cost of the OSPF
interface is 1, but another non-zero value may
be specified. Specify a number from 0 – 65535.
no-multicast
Instructs the SSR to not send multicast packets
to neighbors on point-to-point virtual links.
retransmit-interval
<num>
The number of seconds between link state ad-
vertisement retransmissions for adjacencies be-
longing to this virtual link. Specify a number
equal to or greater than 1.
transit-delay
<num>
The estimated number of seconds required to
transmit a link state update over this virtual
link. Transit delay takes into account transmis-
sion and propagation delays and must be greater
than 0. Specify a number equal to or greater
than 1.
priority
<num>
A number between 0 and 255 specifying the pri-
ority for becoming the designated router on this
virtual link. When two routers attached to a net-