Network Router User Manual
Table Of Contents
- Notices
- Contents
- About This Manual
- Introduction
- Hot Swapping Line Cards and Control Modules
- Bridging Configuration Guide
- Bridging Overview
- VLAN Overview
- Configuring SSR Bridging Functions
- Monitoring Bridging
- Configuration Examples
- SmartTRUNK Configuration Guide
- ATM Configuration Guide
- Packet-over-SONET Configuration Guide
- DHCP Configuration Guide
- IP Routing Configuration Guide
- IP Routing Protocols
- Configuring IP Interfaces and Parameters
- Configuring IP Interfaces to Ports
- Configuring IP Interfaces for a VLAN
- Specifying Ethernet Encapsulation Method
- Configuring Jumbo Frames
- Configuring Address Resolution Protocol (ARP)
- Configuring Reverse Address Resolution Protocol (RARP)
- Configuring DNS Parameters
- Configuring IP Services (ICMP)
- Configuring IP Helper
- Configuring Direct Broadcast
- Configuring Denial of Service (DOS)
- Monitoring IP Parameters
- Configuring Router Discovery
- Configuration Examples
- VRRP Configuration Guide
- RIP Configuration Guide
- OSPF Configuration Guide
- BGP Configuration Guide
- Routing Policy Configuration Guide
- Route Import and Export Policy Overview
- Configuring Simple Routing Policies
- Configuring Advanced Routing Policies
- Multicast Routing Configuration Guide
- IP Policy-Based Forwarding Configuration Guide
- Network Address Translation Configuration Guide
- Web Hosting Configuration Guide
- Overview
- Load Balancing
- Web Caching
- IPX Routing Configuration Guide
- Access Control List Configuration Guide
- Security Configuration Guide
- QoS Configuration Guide
- Performance Monitoring Guide
- RMON Configuration Guide
- LFAP Configuration Guide
- WAN Configuration Guide
- WAN Overview
- Frame Relay Overview
- Configuring Frame Relay Interfaces for the SSR
- Monitoring Frame Relay WAN Ports
- Frame Relay Port Configuration
- Point-to-Point Protocol (PPP) Overview
- Configuring PPP Interfaces
- Monitoring PPP WAN Ports
- PPP Port Configuration
- WAN Configuration Examples
- New Features Supported on Line Cards

SmartSwitch Router User Reference Manual 359
Appendix A: New Features Supported on Line Cards
In addition, these cards support all pre-3.0 firmware features. All cards, except for the
gigabit Ethernet cards, also support WFQ.
The following table lists the line cards introduced for the SSR 8000/8600 with the 3.0
firmware release and the supported features.
Line Cards Introduced at the 3.1 Firmware Release (T-Series)
Line cards introduced at the 3.1 firmware release support the following features:
• Routing table on line card
• Weighted Random Early Detection
• Port rate limiting
• Aggregate rate limiting
• Jumbo frame support (except for 10/100 line cards)
• All features supported by 3.0 line cards—see “Line Cards Introduced at the 3.0
Firmware Release (-AA Revision)” on page 358
In addition, these cards support all pre-3.0 firmware features and WFQ.
The following table lists the line cards introduced for the SSR 8000/8600 with the 3.1
firmware release and the supported features.
Line Card Part
Number
Pre-3.0
SSR
Firmware
Features WFQ Listed 3.0 Features
SSR-HTX12-08-AA
XX X
SSR-HTX22-08-AA
XX X
SSR-HFX21-08-AA
XX X
SSR-HFX29-08-AA
XX X
SSR-GSX21-02-AA
XX
SSR-GLX29-02-AA
XX
SSR-GLX70-01-AA
XX
SSR-SERC-04-AA
XX X
SSR-SERCE-04-AA
XX X
SSR-HSSI-02-AA
XX X