Network Router User Manual
Table Of Contents
- Notices
- Contents
- About This Manual
- Introduction
- Hot Swapping Line Cards and Control Modules
- Bridging Configuration Guide
- Bridging Overview
- VLAN Overview
- Configuring SSR Bridging Functions
- Monitoring Bridging
- Configuration Examples
- SmartTRUNK Configuration Guide
- ATM Configuration Guide
- Packet-over-SONET Configuration Guide
- DHCP Configuration Guide
- IP Routing Configuration Guide
- IP Routing Protocols
- Configuring IP Interfaces and Parameters
- Configuring IP Interfaces to Ports
- Configuring IP Interfaces for a VLAN
- Specifying Ethernet Encapsulation Method
- Configuring Jumbo Frames
- Configuring Address Resolution Protocol (ARP)
- Configuring Reverse Address Resolution Protocol (RARP)
- Configuring DNS Parameters
- Configuring IP Services (ICMP)
- Configuring IP Helper
- Configuring Direct Broadcast
- Configuring Denial of Service (DOS)
- Monitoring IP Parameters
- Configuring Router Discovery
- Configuration Examples
- VRRP Configuration Guide
- RIP Configuration Guide
- OSPF Configuration Guide
- BGP Configuration Guide
- Routing Policy Configuration Guide
- Route Import and Export Policy Overview
- Configuring Simple Routing Policies
- Configuring Advanced Routing Policies
- Multicast Routing Configuration Guide
- IP Policy-Based Forwarding Configuration Guide
- Network Address Translation Configuration Guide
- Web Hosting Configuration Guide
- Overview
- Load Balancing
- Web Caching
- IPX Routing Configuration Guide
- Access Control List Configuration Guide
- Security Configuration Guide
- QoS Configuration Guide
- Performance Monitoring Guide
- RMON Configuration Guide
- LFAP Configuration Guide
- WAN Configuration Guide
- WAN Overview
- Frame Relay Overview
- Configuring Frame Relay Interfaces for the SSR
- Monitoring Frame Relay WAN Ports
- Frame Relay Port Configuration
- Point-to-Point Protocol (PPP) Overview
- Configuring PPP Interfaces
- Monitoring PPP WAN Ports
- PPP Port Configuration
- WAN Configuration Examples
- New Features Supported on Line Cards
Appendix A: New Features Supported on Line Cards
358 SmartSwitch Router User Reference Manual
The following table lists the line cards available for the SSR 8000/8600 prior to the 3.0
firmware release and the supported features.
Line Cards Introduced at the 3.0 Firmware Release (-AA Revision)
Line cards introduced at the 3.0 release support the following features:
• Network address translation
• Load balancing (also known as LSNAT)
•QoS
• Per-flow rate limiting
•ToS rewrite
•Per-protocol VLANs
• Established bit ACLs
• Layer 4 bridging
• Multiple IPX encapsulations
Line Card Part Number
Pre-3.0 SSR
Firmware
Features WFQ
SSR-HTX12-08
XX
SSR-HTX22-08
XX
SSR-HFX11-08
XX
SSR-HFX21-08
XX
SSR-HFX29-08
XX
SSR-GSX11-02
X
SSR-GSX21-02
X
SSR-GLX19-02
X
SSR-GLX29-02
X
SSR-GLX70-01
X
SSR-SERC-04
XX
SSR-SERCE-04
XX
SSR-HSSI-02
XX