Network Router User Manual
Table Of Contents
- Notices
- Contents
- About This Manual
- Introduction
- Hot Swapping Line Cards and Control Modules
- Bridging Configuration Guide
- Bridging Overview
- VLAN Overview
- Configuring SSR Bridging Functions
- Monitoring Bridging
- Configuration Examples
- SmartTRUNK Configuration Guide
- ATM Configuration Guide
- Packet-over-SONET Configuration Guide
- DHCP Configuration Guide
- IP Routing Configuration Guide
- IP Routing Protocols
- Configuring IP Interfaces and Parameters
- Configuring IP Interfaces to Ports
- Configuring IP Interfaces for a VLAN
- Specifying Ethernet Encapsulation Method
- Configuring Jumbo Frames
- Configuring Address Resolution Protocol (ARP)
- Configuring Reverse Address Resolution Protocol (RARP)
- Configuring DNS Parameters
- Configuring IP Services (ICMP)
- Configuring IP Helper
- Configuring Direct Broadcast
- Configuring Denial of Service (DOS)
- Monitoring IP Parameters
- Configuring Router Discovery
- Configuration Examples
- VRRP Configuration Guide
- RIP Configuration Guide
- OSPF Configuration Guide
- BGP Configuration Guide
- Routing Policy Configuration Guide
- Route Import and Export Policy Overview
- Configuring Simple Routing Policies
- Configuring Advanced Routing Policies
- Multicast Routing Configuration Guide
- IP Policy-Based Forwarding Configuration Guide
- Network Address Translation Configuration Guide
- Web Hosting Configuration Guide
- Overview
- Load Balancing
- Web Caching
- IPX Routing Configuration Guide
- Access Control List Configuration Guide
- Security Configuration Guide
- QoS Configuration Guide
- Performance Monitoring Guide
- RMON Configuration Guide
- LFAP Configuration Guide
- WAN Configuration Guide
- WAN Overview
- Frame Relay Overview
- Configuring Frame Relay Interfaces for the SSR
- Monitoring Frame Relay WAN Ports
- Frame Relay Port Configuration
- Point-to-Point Protocol (PPP) Overview
- Configuring PPP Interfaces
- Monitoring PPP WAN Ports
- PPP Port Configuration
- WAN Configuration Examples
- New Features Supported on Line Cards
Chapter 22: Performance Monitoring Guide
310 SmartSwitch Router User Reference Manual
Show information about the master
MAC table.
l2-tables show mac-table-stats
Show information about a
particular MAC address.
l2-tables show mac
Show info about multicasts
registered by IGMP.
l2-tables show igmp-mcast-registrations
Show whether IGMP is on or off on
a VLAN.
l2-tables show vlan-igmp-status
Show info about MACs registered
by the system.
l2-tables show bridge-management
Show SNMP statistics.
snmp show statistics
Show ICMP statistics.
statistics show icmp
Show IP interface's statistics.
statistics show ip
Show unicast routing statistics.
statistics show ip-routing
Show IPX statistics.
statistics show ipx
Show IPX interface's statistics.
statistics show ipx-interface
Show IPX routing statistics.
statistics show ipx-routing
Show multicast statistics.
statistics show multicast
Show port error statistics.
statistics show port-errors
Show port normal statistics.
statistics show port-stats
Show RMON etherStats statistics.
statistics show rmon
Show traffic summary statistics.
statistics show summary-stats
Show most active tasks.
statistics show top
Show TCP statistics.
statistics show tcp
Show UDP statistics.
statistics show udp
Show TACACS server statistics.
tacacs show stats
Show broadcast monitoring
information for ports.
port show bmon [config][detail][port
<port list>
][stats]
Show all VLANs.
vlan list