Network Router User Manual

SmartSwitch Router User Reference Manual 7
Chapter 1: Introduction
without typing the subsystem name in each time. For example, if you are configuring
several entries for the IP routing table, you can simply enter ip at the CLI Configure
prompt. The prompt changes to indicate that the context for the commands to be entered
has changed to that of the IP subsystem. If you type a ?, only those commands that are
valid for the IP subsystem are displayed. The following is an example:
Line Editing Commands
The SSR provides line editing capabilities that are similar to Emacs, a Unix text editor. For
example, you can use certain line editing keystrokes to move forward or backward on a
line, delete or transpose characters, and delete portions of a line. To use the line editing
commands, you need to have a VT-100 terminal or terminal emulator. The line editing
commands that you can use with CLI are detailed in Table 1.
ssr(config)# ip
ssr(config)(ip)# ?
add - Add a static route
dos - Configure specific denial of service features
disable - Disable certain IP function
enable - Enable certain IP function
helper-address - Specify IP helper address for an interface
l3-hash - Change IP hash variant for channel
set - Set ip stack properties
Ctrl-z - Exits to previous level
top - Exits to the top level
ssr(config)(ip)# [Ctrl-Z]
ssr(config)#
Table 1. CLI Line Editing Commands
Command Resulting Action
Ctrl-a
Move to beginning of line
Ctrl-b
Move back one character
Ctrl-c
Abort current line
Ctrl-d
Delete character under cursor
Ctrl-e
Move to end of line
Ctrl-f
Move forward one character
Ctrl-g
Abort current line
Ctrl-h
Delete character just priority to the cursor
Ctrl-i
Insert one space (tab substitution)
Ctrl-j
Carriage return (executes command)