Network Router User Manual

Chapter 21: QoS Configuration Guide
298 SmartSwitch Router User Reference Manual
Specifying Precedence for an IPX QoS Policy
To specify the precedence for an IPX QoS policy, enter the following command in
Configure mode:
Configuring SSR Queueing Policy
The SSR queuing policy is set on a system-wide basis. The SSR default queuing policy is
strict priority. To change the queuing policy to weighted-fair queuing on the SSR, enter the
following command in Configure mode:
If you want to revert the SSR queuing policy from weighted-fair to strict priority (default),
enter the following command in Configure mode:
Allocating Bandwidth for a Weighted-Fair Queuing Policy
If you enable the weighted-fair queuing policy on the SSR, you can allocate bandwidth for
the queues on the SSR. To allocate bandwidth for each SSR queue, enter the following
command in Configure mode:
Specify precedence for an
IPX QoS policy.
qos precedence ipx [srcnet <num>]
[srcnode
<num>] [srcport <num>]
[dstnet
<num>] [dstnode <num>]
[dstport
<num>] [intf <num>]
Set queuing policy to
weighted-fair.
qos set queuing-policy weighted-fair port
<port list>|all-ports input <slot num> |all-
modules
Revert the SSR queuing
policy to strict priority.
negate <line within active-configuration containing qos
set queuing-policy weighted-fair>
Allocate bandwidth for a
weighted-fair queuing policy.
qos set weighted-fair control <percentage>
high
<percentage> medium <percentage>
low
<percentage> port <port list>|all-ports input
<slot num> |all-modules