Network Router User Manual

SmartSwitch Router User Reference Manual 255
Chapter 18: IPX Routing Configuration Guide
To create an IPX access control list, perform the following task in the Configure mode:
Once an IPX access control list has been created, you must apply the access control list to
an IPX interface. To apply an IPX access control list, enter the following command in
Configure mode:
Creating an IPX Type 20 Access Control List
IPX type 20 access control lists control the forwarding of IPX type 20 packets. To create an
IPX type 20 access control list, enter the following command in Configure mode:
Creating an IPX SAP Access Control List
IPX SAP access control lists control which SAP services are available on a server. To create
an IPX SAP access control list, enter the following command in Configure mode:
Once an IPX SAP access control list has been created, you must apply the access control
list to an IPX interface. To apply an IPX SAP access control list, enter the following
command in Configure mode:
Create an IPX access control list. acl <name> permit|deny ipx
<SrcNetwork Node> <DstNetworkNode>
<SrcSocket> <SrcNetMask> <DstSocket>
<DstNetMask>
Apply an IPX access control list.
acl <name> apply interface <Interface Name>
input|output [logging [on|off]]
Create an IPX type 20 access control
list.
acl <name>
permit|deny ipxtype20
Create an IPX SAP access control list. acl <name>
permit|deny ipxsap
<ServerNetworkNode> <ServiceType>
<ServiceName>
Apply an IPX SAP access control list.
acl <name> apply interface
<InterfaceName> input|output
[logging [on|off]]