Network Router User Manual
Table Of Contents
- Notices
- Contents
- About This Manual
- Introduction
- Hot Swapping Line Cards and Control Modules
- Bridging Configuration Guide
- Bridging Overview
- VLAN Overview
- Configuring SSR Bridging Functions
- Monitoring Bridging
- Configuration Examples
- SmartTRUNK Configuration Guide
- ATM Configuration Guide
- Packet-over-SONET Configuration Guide
- DHCP Configuration Guide
- IP Routing Configuration Guide
- IP Routing Protocols
- Configuring IP Interfaces and Parameters
- Configuring IP Interfaces to Ports
- Configuring IP Interfaces for a VLAN
- Specifying Ethernet Encapsulation Method
- Configuring Jumbo Frames
- Configuring Address Resolution Protocol (ARP)
- Configuring Reverse Address Resolution Protocol (RARP)
- Configuring DNS Parameters
- Configuring IP Services (ICMP)
- Configuring IP Helper
- Configuring Direct Broadcast
- Configuring Denial of Service (DOS)
- Monitoring IP Parameters
- Configuring Router Discovery
- Configuration Examples
- VRRP Configuration Guide
- RIP Configuration Guide
- OSPF Configuration Guide
- BGP Configuration Guide
- Routing Policy Configuration Guide
- Route Import and Export Policy Overview
- Configuring Simple Routing Policies
- Configuring Advanced Routing Policies
- Multicast Routing Configuration Guide
- IP Policy-Based Forwarding Configuration Guide
- Network Address Translation Configuration Guide
- Web Hosting Configuration Guide
- Overview
- Load Balancing
- Web Caching
- IPX Routing Configuration Guide
- Access Control List Configuration Guide
- Security Configuration Guide
- QoS Configuration Guide
- Performance Monitoring Guide
- RMON Configuration Guide
- LFAP Configuration Guide
- WAN Configuration Guide
- WAN Overview
- Frame Relay Overview
- Configuring Frame Relay Interfaces for the SSR
- Monitoring Frame Relay WAN Ports
- Frame Relay Port Configuration
- Point-to-Point Protocol (PPP) Overview
- Configuring PPP Interfaces
- Monitoring PPP WAN Ports
- PPP Port Configuration
- WAN Configuration Examples
- New Features Supported on Line Cards
SmartSwitch Router User Reference Manual 199
Chapter 14: Multicast Routing Configuration Guide
Configuring IGMP
You configure IGMP on the SSR by performing the following configuration tasks:
• Creating IP interfaces
• Setting global parameters that will be used for all the interfaces on which DVMRP is
enabled
• Configuring IGMP on individual interfaces. You do so by enabling and disabling
IGMP on interfaces and then setting IGMP parameters on the interfaces on which
IGMP is enabled
• Start the multicast routing protocol (i.e., DVMRP)
Configuring IGMP on an IP Interface
By default IGMP is disabled on the SSR.
To enable IGMP on an interface, enter the following command in Configure mode:
Configuring IGMP Query Interval
You can configure the SSR with a different IGMP Host Membership Query time interval.
The interval you set applies to all ports on the SSR. The default query time interval is 125
seconds.
To configure the IGMP host membership query time interval, enter the following
command in Configure mode:
Configuring IGMP Response Wait Time
You can configure the SSR with a wait time for IGMP Host Membership responses which
is different from the default. The wait time you set then applies to all ports on the SSR. The
default response time is 10 seconds.
Enable IGMP on an interface.
igmp enable interface
<name/ipAddr>
Configure the IGMP host
membership query time interval.
igmp set queryinterval
<num>