Network Router User Manual
Table Of Contents
- Notices
- Contents
- About This Manual
- Introduction
- Hot Swapping Line Cards and Control Modules
- Bridging Configuration Guide
- Bridging Overview
- VLAN Overview
- Configuring SSR Bridging Functions
- Monitoring Bridging
- Configuration Examples
- SmartTRUNK Configuration Guide
- ATM Configuration Guide
- Packet-over-SONET Configuration Guide
- DHCP Configuration Guide
- IP Routing Configuration Guide
- IP Routing Protocols
- Configuring IP Interfaces and Parameters
- Configuring IP Interfaces to Ports
- Configuring IP Interfaces for a VLAN
- Specifying Ethernet Encapsulation Method
- Configuring Jumbo Frames
- Configuring Address Resolution Protocol (ARP)
- Configuring Reverse Address Resolution Protocol (RARP)
- Configuring DNS Parameters
- Configuring IP Services (ICMP)
- Configuring IP Helper
- Configuring Direct Broadcast
- Configuring Denial of Service (DOS)
- Monitoring IP Parameters
- Configuring Router Discovery
- Configuration Examples
- VRRP Configuration Guide
- RIP Configuration Guide
- OSPF Configuration Guide
- BGP Configuration Guide
- Routing Policy Configuration Guide
- Route Import and Export Policy Overview
- Configuring Simple Routing Policies
- Configuring Advanced Routing Policies
- Multicast Routing Configuration Guide
- IP Policy-Based Forwarding Configuration Guide
- Network Address Translation Configuration Guide
- Web Hosting Configuration Guide
- Overview
- Load Balancing
- Web Caching
- IPX Routing Configuration Guide
- Access Control List Configuration Guide
- Security Configuration Guide
- QoS Configuration Guide
- Performance Monitoring Guide
- RMON Configuration Guide
- LFAP Configuration Guide
- WAN Configuration Guide
- WAN Overview
- Frame Relay Overview
- Configuring Frame Relay Interfaces for the SSR
- Monitoring Frame Relay WAN Ports
- Frame Relay Port Configuration
- Point-to-Point Protocol (PPP) Overview
- Configuring PPP Interfaces
- Monitoring PPP WAN Ports
- PPP Port Configuration
- WAN Configuration Examples
- New Features Supported on Line Cards

SmartSwitch Router User Reference Manual xv
Contents
Enabling Cell Scrambling ..............................................................................................45
Cell Mapping..........................................................................................................................46
Selecting the Cell Mapping Format..............................................................................46
Creating a Non-Zero VPI......................................................................................................47
Setting the Bit Allocation for VPI..................................................................................47
Displaying ATM Port Information......................................................................................48
ATM Sample Configuration 1..............................................................................................52
Configuring an Interface on an Ethernet Port............................................................53
Creating a Virtual Channel............................................................................................53
Defining an ATM Service Class....................................................................................53
Applying an ATM Service Class...................................................................................54
Configuring an Interface on an ATM Port..................................................................54
Configuring an IP Route................................................................................................54
Chapter 6: Packet-over-SONET Configuration Guide........................... 57
Overview.................................................................................................................................57
Configuring IP Interfaces for PoS Links......................................................................58
Configuring Packet-over-SONET Links .............................................................................58
Configuring Automatic Protection Switching...................................................................59
Configuring Working and Protecting Ports................................................................60
Specifying Bit Error Rate Thresholds..................................................................................61
Monitoring PoS Ports.............................................................................................................62
Example Configurations .......................................................................................................63
APS PoS Links Between SSRs........................................................................................63
PoS Link Between the SSR and a Cisco Router...........................................................64
Bridging and Routing Traffic Over a PoS Link ..........................................................65
Chapter 7: DHCP Configuration Guide.................................................. 67
DHCP Overview ....................................................................................................................67
Configuring DHCP................................................................................................................68
Configuring an IP Address Pool...................................................................................68
Configuring Client Parameters.....................................................................................68
Configuring a Static IP Address ...................................................................................69
Grouping Scopes with a Common Interface...............................................................69
Configuring DHCP Server Parameters........................................................................70
Updating the Lease Database...............................................................................................70
Monitoring the DHCP Server...............................................................................................70
DHCP Configuration Examples...........................................................................................71
Configuring Secondary Subnets...................................................................................72
Secondary Subnets and Directly-Connected Clients.................................................73
Interacting with Relay Agents.......................................................................................74
Chapter 8: IP Routing Configuration Guide.......................................... 77
IP Routing Protocols..............................................................................................................77
Unicast Routing Protocols.............................................................................................77
Multicast Routing Protocols..........................................................................................78
Configuring IP Interfaces and Parameters.........................................................................78
Configuring IP Interfaces to Ports................................................................................79
Configuring IP Interfaces for a VLAN.........................................................................79