Specifications

SSR Command Line Interface Reference Manual 91
arp add
Note: This option is valid only for the Enable mode arp add
command.
Restrictions
If you enter the arp add command while in the Configure mode, you can add only
permanent ARP entries.
Examples
To create an ARP entry for the IP address 10.8.1.2 at port et.4.7 for 15 seconds:
To create a permanent ARP entry for the host nfs2 at port et.3.1:
ssr# arp add 10.8.1.2 mac-addr 08:00:20:a2:f3:49 exit-port et.4.7 keep-time 15
ssr(config)# arp add nfs2 mac-addr 080020:13a09f exit-port et.3.1