Specifications

SSR Command Line Interface Reference Manual 85
aging l3 set timeout
aging l3 set timeout
Purpose
Set the aging time for a layer 3/4 flow.
Format
aging l3 set timeout <seconds>|disable
Mode
Configure
Description
The aging l3 set timeout command sets the aging time for a layer 3/4 flow. The aging time
is specified in seconds.
Parameters
<seconds> The number of seconds the SSR allows for a layer 3/4 flow. You can specify a
value from 30 to 3600 seconds. For example, in an ISP environment (where
thousands of flows are possible), you could change this value to 180-300 (3-5
minutes) to help in keeping with longer-term flows. The default is 30 seconds.
disable Disables layer 3/4 aging.
Restrictions
None.
Example
To set the layer 3/4 flow aging time to 300 seconds (5 minutes):
ssr(config)# aging l3 set timeout 60