Specifications

SSR Command Line Interface Reference Manual 847
system set poweron-selftest
system set poweron-selftest
Purpose
Specify the type of Power-On-Self-Test (POST) to perform during system bootup.
Format
system set poweron-selftest [on|quick]
Mode
Configure
Description
The system set poweron-selftest command configures the type of Power-On-Self-Test
(POST) the SSR should perform during the next system bootup. By default, no POST is
performed during system bootup. To perform POST, you must use this command to
specify which type of test to run, quick or full. Once POST enabled, to turn off POST, you
simply negate this command (using the negate command).
Parameters
on The SSR will perform a full test during the next system bootup.
quick The SSR will perform a quick test during the next system bootup.
Restrictions
None.