Specifications

SSR Command Line Interface Reference Manual 837
system set daylight-saving
system set daylight-saving
Purpose
Enable daylight saving for the local time zone.
Format
system set daylight-saving
Mode
Configure
Description
If daylight savings time is in effect in the local time zone, use the system set daylight-
saving command to enable it on the SSR. When daylight savings time is in effect, an
additional hour is subtracted from your UCT offset. This command may be required if
you use NTP (Network Time Protocol) to synchronize the system’s real time clock. To
disable daylight savings time on the SSR negate this command.
Parameters
None.
Restrictions
None.
Example
When daylight savings time begins in the local time zone, enable it on the SSR with the
following command:
ssr(config)# system set daylight-saving