Specifications

snmp set target
804 SSR Command Line Interface Reference Manual
snmp set target
Purpose
Sets the target IP address and community string for SNMP traps.
Format
snmp set target <IP-addr> community <community-name> [status enable|disable]
Mode
Configure
Description
The snmp set target command specifies the IP address of the target server to which you
want the SSR to send SNMP traps. Trap targets ar enabled by default but you can use the
status argument to disable or re-enable a target.
Note:
In general, community strings sent with traps should not have read-write
privileges.
Parameters
<IP-addr>
Is the IP address of the management station from which you want to be able to access
the traps.
Note:
The target IP address should be locally attached to the SSR. Cold start traps might
not reach their destination if the target requires dynamic route table entries to be
forwarded correctly. The SSR will retry every minute up to four minutes on the
cold-start trap.
<community-name>
Is the name of the SNMP community for which you are setting the trap target.
status enable|disable
Re-enables or disables the target.