Specifications

SSR Command Line Interface Reference Manual 757
rmon show nl-host
Example
To display the network layer host table for all ports:
Legend:
1. The control table entry for this port:
Index: index number that identifies this entry in the hl host control table.
Port: name of port.
Inserts: number of inserts in the network layer host table for this entry.
Deletes: number of deletions in the network layer host table for this entry.
Owner: the entity that configured this entry.
2. The network address.
3. Number of packets received by this network address.
4. Number of octets received by this network address.
5. Number of packets sent by this network address.
6. Number of octets sent by this network address.
7. The protocol, as defined in the RMON Protocol Directory for the SSR. Note that this
shows the network layer protocol encapsulations only. If you want to see
application/protocol information, such as the destination socket, use the rmon show
al-host command.
ssr# rmon show nl-host all-ports
RMON II Network Layer Host Table
Index: 500, Port: et.5.1, Inserts: 3, Deletes: 0, Owner: monitor
Address InPkts InOctets OutPkts OutOctets Protocol
------- ------ -------- ------- --------- --------
10.60.89.88 1159 952300 2 164 *ether2.ip-v4
192.100.81.1 1 100 1 100 *ether2.ip-v4
192.100.81.3 3 264 1160 952400 *ether2.ip-v4
Index: 504, Port: et.5.5, Inserts: 2, Deletes: 0, Owner: monitor
Address InPkts InOctets OutPkts OutOctets Protocol
------- ------ -------- ------- --------- --------
10.60.89.88 3 246 1220 98962 *ether2.ip-v4
192.100.81.3 1220 98962 3 246 *ether2.ip-v4
1
2 3 4 5 6 7