Specifications

rmon host-top-n
708 SSR Command Line Interface Reference Manual
rmon host-top-n
Purpose
Configures the RMON 1 HostTopN group.
Format
rmon host-top-n index <index-number> host-index <number> [base <statistics>] [duration
<time>] [size <size>] [owner <string>] [status enable|disable]
Mode
Configure
Description
The HostTopN group displays the top n number of hosts, sorted by a specified statistic.
The rmon host-top-n command sets various parameters of the RMON 1 HostTopN
control table. The HostTopN group depends upon the Host group and the host-index
specified in the HostTopN control table must correspond to a pre-defined host index in
the Host control table.
Use the rmon show host-top-n command to display the control table row.
Note that Host Top N report runs once. To run the reports again via the CLI, the control
row must be disabled and then enabled. If the report has already been run, the Time
Remaining field is set to zero. Otherwise, the Time Remaining field will be decremented
until the report is run.
Parameters
<index-number>
Is a number between 1 and 65535 that uniquely identifies a row in the Host Top N
table.
<number>
Is a number between 1 and 65535 that is the index into the host table identified by
hostIndex.