Specifications

rmon hl-matrix
704 SSR Command Line Interface Reference Manual
rmon hl-matrix
Purpose
Configures the RMON 2 Application Layer Matrix and Network Layer Matrix groups.
Format
rmon hl-matrix index <index-number> port <port> nl-max-entries <number> al-max-
entries <number> [owner <string>] [status enable|disable]
Mode
Configure
Description
The rmon hl-matrix command sets various parameters of the RMON 2 Application Layer
Matrix and Network Layer Matrix groups. The Application Layer Matrix group monitors
traffic from the network layer up to the application layer for any protocol communication
defined in the protocol directory. The Network Layer Matrix group monitors traffic at the
network layer for any protocol defined in the protocol directory.
Configuration of the Application Layer/Network Layer Matrix table involves configuring
only one control row in the Application Layer Matrix control table. When configured, this
table captures both application layer and network layer matrix data. If the default tables
were turned on for the Professional group, an entry is created in the Application Layer
Matrix control table for each available port.
Use the rmon show al-matrix command to display the Application Layer Matrix table.
Use the rmon show nl-matrix command to display the Network Layer Matrix table.
Parameters
<index-number>
Is a number between 1 and 65535 that uniquely identifies a row in the application
layer matrix control table.
<port>
Specifies the port from which to collect data.