Specifications

rmon hl-host
702 SSR Command Line Interface Reference Manual
rmon hl-host
Purpose
Configures the RMON 2 Application Layer and Network Layer Host groups.
Format
rmon hl-host index <index-number> port <port> nl-max-entries <number> al-max-entries
<number> [owner <string>] [status enable|disable]
Mode
Configure
Description
The rmon hl-host command sets various parameters of the RMON 2 Application Layer
and Network Layer Host groups. The Application Layer Host group monitors traffic from
the network layer up to the application layer for any protocol communication defined in
the protocol directory. The Network Layer Host group monitors traffic at the network
layer for any protocol defined in the protocol directory.
Configuration of the Application Layer/Network Layer Host table involves configuring
only one control row in the Application Layer Host control table. This table, when
configured, captures both application layer and network layer host data. If the default
tables were turned on for the Professional group, an entry is created in the Application
Layer Host control table for each available port.
Use the rmon show al-host command to display the Application Layer Host table. Use the
rmon show nl-host command to display the Network Layer Host table.
Parameters
<index-number>
Is a number between 1 and 65535 that uniquely identifies a row in the application
layer host control table.
<port>
Specifies the port from which to collect data.