Specifications

SSR Command Line Interface Reference Manual 667

rip set preference

Purpose

Sets the preference of routes learned from RIP. The default preference is 100. This

preference may be overridden by a preference specified in the import command.

Format

rip set preference <num>

Mode

Configure

Description

The rip set preference command sets the preference for destinations learned through RIP.

The preference you specify applies to all IP interfaces for which RIP is enabled on the SSR.

The default preference is 100. You can override this preference by specifying a different

preference in an import policy.

Parameters

<num> Specifies the preference. Specify a number from 0 – 255. The default is 100. Lower

numbers have higher preference.

Restrictions

None.