Specifications

SSR Command Line Interface Reference Manual 659
rip set check-zero
rip set check-zero
Purpose
Specifies whether RIP should make sure that reserved fields in incoming RIP V1 packets
are zero. Normally, RIP will reject packets where the reserved fields are non-zero.
Format
rip set check-zero disable | enable
Mode
Configure
Description
The rip set check-zero command specifies whether RIP should make sure that reserved
fields in incoming RIP V1 packets are zero. RIP will reject packets where the reserved
fields are non-zero.
• If you use the disable keyword, RIP does not check the reserved field.
• If you use the enable keyword, RIP on the SSR checks to ensure that the reserved fields
in incoming RIP packets are zero. If the reserved field in a RIP packet is not zero, the
SSR discards the packet. This is the default state.
Parameters
disable | enable
Enables or disables checking of the reserved field.
Restrictions
None.