Specifications

SSR Command Line Interface Reference Manual 601
qos set l2
source-mac <MACaddr>
Specifies the L2 source MAC address. Specify the MAC address in either of the following
formats:
xx:xx:xx:xx:xx:xx
xxxxxx:xxxxxx
dest-mac <MACaddr>
Specifies the L2 destination MAC address.
vlan <vlanID>
Specifies the name of a VLAN.
in-port-list <port-list>
Specifies the SSR ports for which you are setting priority for this flow. The priority
applies when the L2 packet enters the SSR on one of the specified ports. The priority
does not apply to exit ports.
priority control|high|medium|low|<trunk-priority>
Specifies the priority you are assigning to the flow parameters you specified from the
list above. You can specify one of the following priorities:
control Assigns control priority to the IPX flow parameters you have
specified. This is the highest priority.
high Assigns high priority to the IPX flow parameters you have specified.
medium Assigns medium priority to the IPX flow parameters you have
specified.
low Assigns low priority to the IPX flow parameters you have specified.
This is the default.
<trunk-priority> Assigns n 802.1Q VLAN trunk priority when the exit port is a VLAN
trunk port. The SSR maps the number to the four internal priorities as
follows: 0 = low; 1, 2, or 3 = medium; 4, 5,or 6 = high; 7 = control.
Restrictions
None.