Specifications

qos set l2
600 SSR Command Line Interface Reference Manual
qos set l2
Purpose
Configure priority for a Layer 2 flow.
Format
qos set l2 name <name> source-mac <MACaddr> dest-mac <MACaddr> vlan <vlanID> in-
port-list <port-list> priority control | high | medium | low | <trunk-priority>
Mode
Configure
Description
The qos set l2 command lets you set QoS priority on a Layer 2 flow. You can set priorities
on the following fields in the flow:
•L2 flow name
• Source MAC address
• Destination MAC address
•VLAN ID
•Incoming port(s)
You can set the priority of each field in one of the following ways:
• The flow is assigned a priority within the switch. In this case you specify a priority of
control, low, medium, or high. The default is low.
• The flow is assigned a priority within the switch, but in addition, if the exit ports are
VLAN trunk ports, the flow is assigned an 802.1Q priority. In this case you specify a
number from 1 – 7. The SSR maps the number to the four internal priorities as follows:
0 = low; 1, 2, or 3 = medium; 4, 5,or 6 = high; 7 = control.
Parameters
name <name>
Specifies the L2 flow name.