Specifications

qos set ipx
598 SSR Command Line Interface Reference Manual
control Assigns control priority to the IP flow parameters you have specified. This
is the highest priority.
high Assigns high priority to the IP flow parameters you have specified.
medium Assigns medium priority to the IP flow parameters you have specified.
low Assigns low priority to the IP flow parameters you have specified. This is the
default.
<srcnet>|any
Specifies the IPX source network and node address. Specify them in the following
format: <netaddr>.<macaddr>; for example:
a1b2c3d4.aa:bb:cc:dd:ee:ff.
If you specify any instead of a .<macaddr>, the SSR assumes a wildcard value. All MAC
addresses are then valid.
<srcmask>|any
Specifies the IPX source network mask. Specify the mask in hexadecimal digits. If you
do not specify a mask value and instead use the value any, the SSR internally sets the
mask to FFFFFFFF.
<srcport>|any
Specifies a port number from 1 – 65535 or any to allow any value.
<dstnet>|any
Specifies the IPX destination network and node address. The same requirements and
restrictions for <dstaddr> apply to <srcaddr>.
<dstmask>|any
Specifies the IPX destination network mask. Specify the mask in hexadecimal digits or
any to allow any value.
<dstport>|any
Specifies a port number from 1 – 65535 or any to allow any value.
<interface-list>|any
If you specify a list, delimit the interface names with commas. Specify any to allow
any IPX interface name.
Restrictions
None.