Specifications
SSR Command Line Interface Reference Manual 595
qos set ip
<priority>
Specifies the priority you are assigning to the flow parameters you specified from the
list above. You can specify one of the following priorities:
control Assigns control priority to the IP flow parameters you have specified. This
is the highest priority.
high Assigns high priority to the IP flow parameters you have specified.
medium Assigns medium priority to the IP flow parameters you have specified.
low Assigns low priority to the IP flow parameters you have specified. This is the
default.
<srcaddr/mask>|any
Specifies the source IP address and network mask for which you are assigning a
priority. You can specify the mask using the traditional IP address format
(“255.255.0.0”) or the CIDR format (“/16”).
If you specify any instead of a network mask, the SSR assumes a wildcard “don’t care”
condition. If you do not specify a mask, then the SSR assumes a mask of
255.255.255.255. You cannot substitute the mask with the any keyword. The keyword
any is for the entire <srcaddr/mask> pair.
<dstaddr/mask>|any
Specifies the destination IP address and network mask for which you are assigning a
priority. The same requirements and restrictions for <srcaddr/mask> apply to
<dstaddr/mask>.
If you specify any instead of a network mask, the SSR assumes a wildcard “don’t care”
condition. If you do not specify a mask, then the SSR assumes a mask of
255.255.255.255. You cannot substitute the mask with the any keyword. The keyword
any is for the entire <dstaddr/mask> pair.
<srcport>|any
Specifies the source TCP or UDP port for which you are assigning a priority. Specify a
port number from 1 – 65535 or any to allow any value.
<dstport>|any
Specifies the destination TCP or UDP port for which you are assigning a priority.
Specify a port number from 1 – 65535 or any to allow any value.
<tos>|any
Specifies the TOS for which you are assigning a priority. Specify a number from 0– 15
or any to allow any value.
<interface-list>|any
Specifies one or more IP interface names for which you are assigning priority. If you
specify a list, delimit the interface names with commas. Specify any to allow any IP
interface name.