Specifications

pvst set port spanning-tree
584 SSR Command Line Interface Reference Manual
pvst set port spanning-tree
Purpose
Set PVST port priority and port cost for ports for a particular VLAN.
Format
pvst set port <port-list> priority <num> port-cost <num> spanning-tree <string>
Mode
Configure
Description
The pvst set port command sets the STP priority and port cost for individual ports for a
particular VLAN.
Parameters
port <port-list>
The port(s) for which you are setting STP parameters. You can specify a single port or
a comma-separated list of ports. Example: et.1.3,et.(1-3).(4,6-8).
priority <num>
The priority you are assigning to the port(s). Specify a number from 0– 255. The
default is 128.
port-cost <num>
The STP cost you are assigning to the port(s). Specify a number from 1– 65535. The
default depends on the port speed: 1 for Gigabit (100-Mbps) ports, 10 for 100-Mbps
ports, and 100 for 10-Mbps ports.
spanning-tree <string>
The name of the spanning-tree instance. This name is the same as the VLAN name.
Note:
For default VLAN, use stp commands.